All in one buttons earrings are my favorite not only to wear but to make. They look elegant without being too dangly. Choose good looking buttons and you'll soon be cranking them out. I should also mention they are very fast to make. All you need are the buttons and some wire and you are good to go.
What you need :
- Shank buttons about 1.5 cm in diameter; the buttons I used were courtesy of TierraCast
- 20G wire, I used jewelry bronze for this pair because it looks like gold
- round nose pliers
- chain nose pliers
- flush cutters
- nylon jawed pliers - or use a folded paper towel
- large bail forming pliers (or use a dowel or marker pen)
- sanding pad or cup bur
- nylon hammer and steel block
 |
| TierraCast shank buttons |
Cut 4 inches of wire and use the tip of your round nose pliers to bend it to unequal lengths - 1.5 inch and 2.5 inch.
Hook the bent wire through the button shank with the short end on the left (reverse if you are lefthanded). If the button has a one way design, make sure the wire is sitting at the top.
As a right hander, I then grabbed the short wire end and bent it under the long wire end and down the shank and up the other side. This is a little tricky - just make sure the long wire stays, pointing up.
Trim the short wire end and use your chain nose pliers to tuck it in.
If the long wire got kinked, straighten it with the nylon jawed pliers. You can also stroke the wire using a folded up paper towel.
Bend the wire to the front of the button like so :
Place the smaller barrel of the bail forming pliers below and against the button. Then bend the long wire over the larger barrel. The wire should look like it is part of an ear wire which it is!
Trim the wire to the desired length. You can use your chain nose pliers to put a little kink at the end. But a broad nose pliers will mean consistent bends all the time.
Don't forget to remove the burs. Check out this tutorial post,
How to Debur Ear Wires.
Also hammer lightly with a nylon hammer to work harden and set the shape of the ear wires. Make the other side and you're done! Have fun!
Check the links below for my other all in one earring tutorials.
Photography All images were taken with my iPhone 5 with the camera+ app on the Modahaus photo studio and steady stands. The tutorial pictures were captured using artificial lights in my windowless basement studio. Final design pictures were taken in natural daylight. Check here to find out more about my
How to Photograph Jewelry Webinars. Before You Go: ______________________________
Original Post by
THE BEADING GEM Jewelry Making Tips -
Jewelry Business Tips 
No comments:
Post a Comment